9410 MLCS Heavy Duty Router Speed Control 20 amp
MLCS Heavy Duty Router Speed Control 20 amp allows a woodworker to reduce the speed of a router without reducing torque. Electronic feedback maintains speed by increasing voltage to motor as load increases. Work at the best speed for the bit and the wood. Recommended for industrial and commercial use. Simply plug in speed control then plug your router into the speed control. Adjust speed from 0 RPM to full speed.
WARNING:
NOTICE:
LOADS OVER 15 AMPS ONLY.
WARNING:
- Will not work with soft start or variable speed routers.
- Will not work with "AC capacitor start induction" type motors.
NOTICE:
LOADS OVER 15 AMPS ONLY.
- Variable Speed Controllers are calibrated to the amperage load of the tool connected to it. The 20 AMP Variable Speed Controller is factory calibrated for amperage loads OVER 15 AMPS. If your tool does not have a load OVER 15 AMPS, your tool will not work properly with this Variable Speed Controller.
Special Price
$57.99
was
$60.99
5% OFF
You save $3.00
Model# 9410
SKU
645710036880
This item may qualify for an upto 5% OFF further discount. Check Eligibility.
Features:
- Less tear out • Stops burning • Feed at comfortable rate.
- Better, safer results with large diameter panel raising bits.
- Less wear on bits • Less noise • Softer starts at lower speeds.
- Adjustable speed from 0 RPM to full speed.
- 3 position rocker switch- Variable / Off / Full Speed.
- Full power and torque at all speeds.
- Go back and forth from any preset speed to full speed at the flip of a switch.
- Works with most routers 3-1/4 HP or less • 120V.
- Give your router a feature only available on expensive routers.
- Easy to use- Simply plug in speed control and plug your router into the speed control- turn dial slowly for best results. (Speed control has a clip that can be worn on your belt, hung on wall, or left loose).
| Brand | MLCS |
|---|---|
| Model# | 9410 |
| CA Prop 65 |